Middle Gear Reassembly

Submitted by xjcdadmin on Sun, 05/30/2010 - 09:23

6. Middle gear (installation only, refer to page 67 for the middle gear adjustment)

a. Install the middle drive gear assembly with the proper size of shim(s) and secure it with the bearing retainers and new "TORX" screws.

Tightening torque: 2.5 m-kg (18 ft-lb)

1. Shims

b. Stake the screw heads to the dents on the bearing retainers with a center punch.

c. Install the driven gear assembly with the proper size of shims and secure it with the bolts. Apply a thread locking compound such as "LOCTITE" to the bolt threads,

Tightening torque:

2.5 m-kg (18.1 ft-lb)


1. Shims

d. Install the middle gear case half moon seal onto the crankcase.


1. Seal

7. Shifter assembly

a. Install the shift shaft assembly with the stopper lever.

b. Install the shift lever assembly with the positioning spring is properly located on the stopper pin and the teeth should be set properly as shown.

 

c. Install the left crankcase cover (shifter cover) using a new gasket. Make sure the wire harness clips are properly positioned.

Tightening torque: 1.0m-kg(7.2ft-lb)