750RK (Seca)

Lubrication Diagrams

LUBRICATION DIAGRAMS

 

Electrical Component Locations

ELECTRICAL COMPONENTS

Parts Illustrations

PARTS ILLUSTRATIONS 

Transmission -- Inspection and Repair

L. Transmission

1. Inspect each shift fork for signs of galling on gear contact surfaces. Check for bending. Make sure each fork slides freely on its guide bar.

2.    Roll the guide bar across a surface place. If the bar is bent, replace.

Tags:

Middle Gear Adjustment

 

C. Middle Gear Servicing

1.    Disassembly

Refer to page 39 for disassembly.

2.    Inspection

Refer to page 52 for inspection.

3.    Gear lash check

NOTE:

Tags:

Electric Starting System

 

 

Starting circuit operation

 

The starting circuit on this model consists of the starter motor, starter relay, and the starting-circuit cut-off relay. If the engine stop switch and the main switch are both on, the starter motor can operate only if:

 

Ignition System

E. IGNITION SYSTEM

Above circuit diagram shows only ignition circuit in wiring diagram.

Description

Lower Crankcase Disassembly

L. Lower Crankcase

1.    Remove the dowel pin and "O-ring".

2.    Remove the shift fork guide bar and shift forks. The shift forks are identified by numbers cast on their sides.

3.    Remove the bolt securing the shift cam locating pin and remove the stopper plate and locating pin.

Tags:

Generator, Starter and Pick-up Coil Reassembly

8. A.C. Generator

a. Install the rotor onto the shaft and tighten the bolt using the rotor holding tool (special tool) as shown.


1. Rotor holding tool

Tightening torque: 5.5 m-kg (39.8 ft-lb)

b. Install the stator coil assembly onto the crankcase and align the grooves on the stator core with the bolt holes on the crankcase.

Tags:

Oil Pump and Middle Gear Disassembly

H. Oil Pump Removal and Disassembly

1. Remove the strainer cover. Note the wire harness clip position.

2. Remove the oil pump securing bolts and remove the sprocket cover and oil pump assembly.

CAUTION:

Tags: