650G (Maxim)

Upper Crankcase Reassembly

Submitted by xjcdadmin on Wed, 06/10/2009 - 17:02

ENGINE ASSEMBLY AND ADJUSTMENT

A. Important Information

1.    Gasket and seal

All gaskets and seals should be replaced when an engine is overhauled. All gasket surfaces and oil seal lips must be cleaned.

2.    Properly oil all mating engine and transmission parts and bearings during reassembly.

3.    Circlip

Signals

Submitted by xjcdadmin on Wed, 06/10/2009 - 17:02

SIGNAL SYSTEM 

A. Circuit Diagram

Above circuit diagram shows only signal circuit in wiring diagram.

B. Signal System Tests and Checks

Middle Gear Reassembly

Submitted by xjcdadmin on Wed, 06/10/2009 - 17:02

6. Middle gear (installation only, refer to page 67 for the middle gear adjustment)

a. Install the middle drive gear assembly with the proper size of shim(s) and secure it with the bearing retainers and new "TORX" screws.

Tightening torque: 2.5 m-kg (18 ft-lb)

1. Shims