General Information and Operation
CARBURETION
CARBURETOR
- Read more about General Information and Operation
- Log in to post comments
CARBURETION
CARBURETOR
CABLE ROUTING (1)
FRONT FORK
INSPECTION
1. Inspect the starter plunger 1 for damage. Replace if damaged or worn.
• Vacuum piston 2. Replace if scratched/worn.
•Throttle valve diaphragm 3. Replace if torn or damaged.
PREPARATION FOR REMOVAL
1. Remove all dirt, mud, dust, and foreign material before removal and disassembly.
2. Use proper tools and cleaning equipment. Refer to CHAPTER 1, "SPECIAL TOOLS."
REMOVAL AND DISASSEMBLY
NOTE:
Be sure to drain the coolant before disassembly of the cooling system components.
1. Drain the engine oil
SWINGARM AND REAR SHOCK ABSORBER
1 Rear shock absorber
2 Swingarm
3 Bearing
4 Oil seal
5 Collar
6 Lock washer
7 Left pivot shaft
8 Pivot cover
9 Right pivot shaft
10 Nut
11 Rubber boot
12 Spring band
1. Refer to engine removal. Reverse those removal steps that apply.
2. Tighten engine mounting bolts
Engine Mounting Bolt: Front 1: 42 Nm (4.2 m-kg, 30 ft-lb)
Rear 2 : 90 Nm (9.0 m-kg, 65 ft-lb)
Down Tube 3 , Bracket 4 : 33 Nm (3.3 m-kg, 24 ft-lb)