700XNC (MaximX)

Middle Gear Service

Submitted by xjcdadmin on Tue, 06/08/2010 - 01:10

MIDDLE GEAR SERVICE

 

 

1   Spring retainers
2    Spring seat
3    Damper cams
4   Midde drive gear shim 
5   Bearing
6   Bearing retainer
7    Middle drive shaft
8    Middle driven shaft
9   Shim 
10 O-ring
11 Bearing housing
12 Oil seal (35 x 5 0x6)

 

Water Pump

Submitted by xjcdadmin on Tue, 06/08/2010 - 01:10

REMOVAL AND DISASSEMBLY

NOTE:
Be sure to drain the coolant before disassembly of the cooling system components.

1. Drain the engine oil

 

General Torque Specifications

Submitted by xjcdadmin on Tue, 06/08/2010 - 01:10

GENERAL TORQUE SPECIFICATIONS

This chart specifies torque for standard fasteners with standard l.S.O. pitch threads. Torque specifications for special components or assemblies are included in the applicable sections of this book. To avoid warpage, tighten multi-fastener assemblies in a criss-cross fashion, in progressive stages, until full torque is reached. Unless otherwise specified, torque specifications call for clean, dry threads. Components should be at room temperature.

Subscribe to 700XNC (MaximX)