750XN (MaximX)

FRONT FORK

FRONT BRAKE

REAR WHEEL

FRONT WHEEL

1  Wheel axle
2   Collar
3   Oil seal
4   Bearing
5   Spacer
6   Speedometer gear unit
7   Tire

SHAFT DRIVE

Refer to "CHAPTER 3". for the middle gear.

The following special tools are not available but can be constructed for the final gear disassembly and assembly:

1. Measure fuel level. Adjust if out of specification.

Measurement steps:

• Place the motorcycle on a level surface.
• Shim the center stand as required to level from side to side using a level across the carb bank

INSPECTION

1. Inspect the starter plunger 1 for damage. Replace if damaged or worn.

• Vacuum piston 2. Replace if scratched/worn.

•Throttle valve diaphragm 3. Replace if torn or damaged.

REMOVAL

1. Remove carburetor assembly. Refer to engine removal section.

NOTE: The following parts can be cleaned and inspected without disassembly.
• Piston valve
• Jet needle

2.  Disconnect:

CARBURETION

CARBURETOR