650H (Euro)

Cleaning the Hitachi Carb

Submitted by xjcdadmin on Wed, 12/19/2012 - 22:45

This series assumes you took the carbs apart, and are trying to figure out how to put them back together again. If you haven’t taken them apart yet, it’s a good idea to skim through this first anyway. Address any questions to: xj-owners@micapeak.com, and we’ll try to talk you through it.

 

Pictures and text by Dwayne Verhey

Lower Crankcase Reassembly

Submitted by xjcdadmin on Wed, 06/10/2009 - 17:02

2. Lower crankcase

a.   Install the shift cam and secure it with the guide pin. Install the stopper plate and bolt and tighten securely.

b.   Install the neutral switch.

c. Install the transmission drive axle assembly into the crankcase.

Clutch and Shifter Reassembly

Submitted by xjcdadmin on Wed, 06/10/2009 - 17:02

5. Clutch assembly

a. Install the thrust plate onto the transmission main axle.

1. Thrust plate

b. Install the oil pump drive sprocket onto the main axle without the spacer collar and place the oil pump drive chain on its sprocket.

1. Oil pump drive sprocket

Pistons and Cylinder Reassembly

Submitted by xjcdadmin on Wed, 06/10/2009 - 17:02

11. Pistons and Cylinder a. Install the pistons on the rods. The arrow on the piston must point to the front of the engine.

NOTE:--------------------------------------------------------

Before installing the piston pin clips, cover

the crankcase with a clean rag so you will

not accidentally drop the circlip into the

crankcase.

Cylinder Head and Camshaft Reassembly

Submitted by xjcdadmin on Wed, 06/10/2009 - 17:02

12. Cylinder head and Cam shafts 

a. Install the new cylinder head gasket. Install the dowel pins and "O-rings". Locate the cam chain cavity cylinder seal with the tabs down.

b.   Install the cylinder head onto the cylinder. Pull the cam chain through the cylinder head as it is installed. Tie the cam chain so that it does not fall into the crankcase.

Upper Crankcase Reassembly

Submitted by xjcdadmin on Wed, 06/10/2009 - 17:02

ENGINE ASSEMBLY AND ADJUSTMENT

A. Important Information

1.    Gasket and seal

All gaskets and seals should be replaced when an engine is overhauled. All gasket surfaces and oil seal lips must be cleaned.

2.    Properly oil all mating engine and transmission parts and bearings during reassembly.

3.    Circlip