Maintenance Specifications -- Electrical
Electrical
|
Voltage: 12V |
Ignition System: Ignition Timing (B.T.D.C.) 5° at 1,100 r/min |
- Read more about Maintenance Specifications -- Electrical
- Log in to post comments
750XN (MaximX)
Radiator & Filling
REMOVAL
1. Drain coolant
2. Remove radiator assembly
Refer to CHAPTER 3 "ENGINE REMOVAL".
INSPECTION
- Read more about Radiator & Filling
- Log in to post comments
Front Wheel
FRONT WHEEL
1 Wheel axle
2 Collar
3 Oil seal
4 Bearing
5 Spacer
6 Speedometer gear unit
7 Tire
- Read more about Front Wheel
- Log in to post comments
Cooling System
COOLING SYSTEM
3 Main switch
4 Fuse "FAN" (10A)
5 Thermo switch
6 Fan motor
18 Temperature meter
19 Thermo unit
35 Fuse "SIGNAL" (15A)
48 Battery
49 Fuse "MAIN" (30A)
- Read more about Cooling System
- Log in to post comments
Lubrication Diagrams
LUBRICATION DIAGRAM
- Read more about Lubrication Diagrams
- Log in to post comments
Electric Starting System
ELECTRIC STARTING SYSTEM
- Read more about Electric Starting System
- Log in to post comments
Front Brake
FRONT BRAKE
- Read more about Front Brake
- Log in to post comments
General Specifications
GENERAL SPECIFICATIONS
|
Item |
Model |
XJ750XN |
Model Code Number Federal V.I.N. Number Engine Starting Number |
- Read more about General Specifications
- Log in to post comments
Installing Carbs into old, dry rubber manifolds
INSTALLATION
1. Install carburetors: Reverse the removal steps.
Yeah, right...
Maxim X Carburetor Installation
A Technique for reinstalling old hardened intake boots. (Note: This will probably not work on other models with long boots)
This is not a Yamaha procedure. It was developed by Joe D. HAP and dv
Carburetor Overhaul
REMOVAL
1. Remove carburetor assembly. Refer to engine removal section.
NOTE: The following parts can be cleaned and inspected without disassembly.
• Piston valve
• Jet needle
2. Disconnect:
- Read more about Carburetor Overhaul
- Log in to post comments