Engine Assembly and Adjustment

Submitted by xjcdadmin on Thu, 06/27/2013 - 10:26
Model(s)

Important information

1.      All gaskets and seals should be replaced when an engine is overhauled. All gasket surfaces and oil seal lips must be cleaned.

2.      Properly oil all mating engine and transmission parts and bearings during reassembly.

3.      All circlips should be inspected carefully before reassembly. Always replace piston pin clips after one use. Replace distorted circlips. When installing a circlip, make sure that the sharp edged corner is positioned opposit to the thrust it receives. See the sectional view below.

4. All lock washers/plates and cotter pins must be replaced when they are removed. Lock washer/plate tab(s) should be bent over along the bolt or nut flat(s) after tightening the bolt or nut properly (see illustration).

Cotter pins should be replaced after one use.